CAR SET UP

CAN    DO’S

1. Use all threads to secure hood.All threads cannot be welded to the frame or through the frame. 4 max.
2. Bumpers can be chained. Chain size not to exceed 1/4". Subject to official approval.
3. Bumpers can be welded to bumper brackets and brackets can be welded to the frame.
4. Rear bumpers can be welded to the trunk. 
5. Shock absorber bumpers can be welded solid or removed and replaced with bumper brackets. 
6. Bumpers can be trimmed. 
7. Fenders can be trimmed for additional tire clearance not to exceed 8". 
8. Body can be removed and bolted solid to the frame. 
9. Doors can be chained or welded. Weld straps over door seams not to exceed 1/16” thick and 1” wide. 
10. Trunks can be welded solid.  Welds only - NO back up plates.
11. Coil springs can be tack welded.
12. Rear axles can have limiting chains installed, but not tight.
13. Stock gas tank or metal boat tank can be used.
14. Transmission cooling tanks can be used.
15. Dash boards can be removed and replaced with 3” o.d. cowl bar.
16. Driver’s door and front passenger door can be reinforced for driver protection.
17. Motor mounts can be solid.

CAR SET UP

CANNOT   DO’S:

1. No Chrysler Imperials – no Commercial vehicles, no Hearses, no Compact vehicles.
2. No full cages.
3. No extra radiator cooling tanks. Radiator stays in stock location.
4. No hand held starting fluid.
5. No after market rear ends - rear ends must be consistent with make and model of car.
6. No added reinforcement to bumper or bumper brackets.
7. No reinforcing or welding hood to fenders.
8. No solid suspension.
9. No switching of suspension parts from original; i.e. coils to leaf springs.
10. No off-road or implement tires. No foam filled tires. All tires subject to approval.
11. No reinforcement inside the car other than as described in the accompanying diagram. Refer to diagram.
12. No reinforcement pipe larger than 3" o.d.
13. No reinforcement of any suspension parts, steering components including wheels, tie rods, a-frames, etc.
14. No reinforcement of any type on the outside of the car.
15. Body cannot be welded to the frame.
16. No additional reinforcement of frames, fenders, radiator core or core support.
17. No reinforcement of tire rims.
18. No full windshield screens.
19. No side window bars. Hard tops accepted; 2” strap max top to bottom of window.
20. No aftermarket fuel pumps.
21. No trailer hitches or trailer hitch assemblies allowed.

*Protest $150 fee on main event winner vehicle only.  Vehicle will be impounded for examination the following morning at 9 AM.

CAR SET UP

MUST   DO’S:

1. All glass, chrome, Pot metal handles, upholstery, headliners, floor mats and rear seat must be removed.
2. Must have a driver lap seat belt.  Shoulder straps optional.
3. Driver’s side door must be padded with suitable padding for driver protection.
4. Stock gas tank must be removed from stock location.
5. Stock gas tank must be reinstalled in the center where the back seat used to be.
6. Suitable boat gas tank or military type gas can may be used in place of stock gas tank. Install in the center where the rear seat used to be.
7. All tanks and their installation are subject to official approval.
8. If vehicle is factory fuel-injected, with fuel pump inside gas tank, a master kill switch must be installed and readily and easily accessible to outside emergency personnel.  The switch needs to be clearly identified. THIS COULD SAVE YOUR LIFE!
9. Batteries must be sealed or have anti-spill caps and all batteries must be covered with suitable material for driver protection.
10. Batteries must be securely attached in a battery holder and secured to the floor at least 4 ft. from driver and gas tank.
11. Driver’s door must have metal reinforcement not to exceed past driver’s door compartment. For driver protection only.
12. Trunks must be empty.  No spare tires or extra weight.
13. All cars must have a fire wall between the driver and engine compartment.
14. All gas lines must be routed in a safe manner with proper fittings and clamps.
15. Hoods must have at least a one 8"  hole in center for fire extinguisher access.
16. All drivers’ doors must be painted a contrasting color with word "STOP" or a "STOP" sign painted on it. “DO IT”.
17. All cars must have a large number plate on top of the car with racing numbers on both sides of plate. Also recommended on the sides of the car.
18. Driver must have racing type helmet, suitable eye protection, long pants and long sleeve shirt.  Gloves optional.  Fire suit recommended but not required.
19. Every pit must have a fire bottle readily accessible.